When two polarizing filters are arranged along perpendicular axes, as in the first illustration, light passes through the lead filter and follows the helix arrangement of the liquid crystal molecules. The light is twisted 90 degrees, thus allowing it to pass through the lower filter. When voltage is applied, however, the liquid crystal molecules straighten out of their helix pattern. Light is blocked by lower filter and the screen appears black because of there being no twisting effect. 

The multiplex rate is equal to the number of rows that can be displayed simultaneously. For example, a display with a multiplex rate of 16 can display 16 rows of information simultaneously.

ETN segment type displays are ideal solutions for electronic products which requiring high readability such as audio, aire conditioner controller etc.

Produces images in two modes: 

(1)Positive and Negative. Positive Mode provides white background with black segments. 

(2)Negative Mode provides black background and white segments.   

When two polarizing filters are arranged along perpendicular axes, as in the first illustration, light passes through the lead filter and follows the helix arrangement of the liquid crystal molecules. The light is twisted 110 degrees, thus allowing it to pass through the lower filter. When voltage is applied, however, the liquid crystal molecules straighten out of their helix pattern. Light is blocked by lower filter and the screen appears black because of there being no twisting effect.

The graph shows a comparison of a voltage versus transmitted light curve of a typical TN and a supertwist nematic (STN) display. (Generally, a greater twist angle equates to higher multiplexibility.) The V90 and V10 points on the graph indicate the voltages that yield 90 percent and 10 percent light transmission, respectively. 

As the figure shows, STN displays have a steeper curve than TN displays, which allows higher multiplex levels for STN displays. (STNs were developed primarily to overcome the difficulties encountered in multiplexing TN displays.) 

The multiplex rate is equal to the number of rows that can be displayed simultaneously. For example, a display with a multiplex rate of 400 can display 400 rows of information simultaneously.

Features: 

1.Transmissive Negative Mode 

2.Wide operating temperature range 

3.Supper Wide Viewing Angel 

4.High brightness 

5.High contrast ratio 

6.Duty Ratio: 1:8~1:136

The film (the top layer in the figure) is placed in the display, either under or over the top polarizer. Some film compensation systems use two films, one on the rear that serves as a collimator, and one on the front that serves as a dispersion film to broaden the viewing cone. Film compensation improves the viewing angle, but does not affect switching time. FSTN is all standard STN displays with a polymer film applied to the glass as a compensation layer instead of the second cell as in the case of the DSTN. This simpler and more importantly cost effective method provides the preferred black on white image for this display technology.

LCD with an extra special TEP (Temperature match Elliptical Polarizer) compensation film added to the outside of the cell. TEP is used as a compensator which can increases contrast and gives the black on white appearance. 

Features: 

1.Thin and reduced weight. 

2.Easy to laminate. 

3.Higher brightness through reduced reflections. 

4.Temperature compensated driving necessary.   

― Improved switching times at low temperature. 

5.Cost effective.

BM STN type displays are ideal solutions for Instruments Medical diagnostic applications (Blood Pressure Monitors), Home appliance (coffee machine, audio etc.)